Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION MANUAL
Installation instructions and door reversibility
Installation
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
! Check the installation dimensions according to fig.C. The position of the joint between
the unit doors must be level with the position of the joint between the appliance doors.
1. See fig.A for the necessary attachment components.
2. Insert trim flap
1
3. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (fig.B - fig.C)
4. Take out the trim gasket
reverse side of the door hinges of the appliance. (fig.D - fig.E)
5. Raise appliance and slide into kitchen unit. Push appliance to the reverse side of door
hinges providing that trim gasket
6. Align front feet with front surface of kitchen unit. (fig.F)
7. Screw the front feet by using screws
8. Screw trim flap
1
9. Screw fixing bracket
opposite side. (fig.H)
10. Screw guides
to appliance doors with screws
3
is opened at right angle. Slide rails
the unit doors with screws
11. Set 1~2 mm gap on handle side between unit itself and unit doors by adjusting guides
That is vital for appliance performance. (fig.J)
into slot and screw by screws
located on the side panel of the appliance and stick it on
2
covers space between appliance and the kitchen unit.
2
to kitchen unit using screws
, as leaned to kitchen unit by using screws
11
into guides
4
. (fig.J)
5
. (fig.D)
6
. (fig.F)
5
. (fig.G)
5
. Lean appliance doors to unit door as it
6
aligning the groove. Screw the rails
3
EN - 14 -
. Repeat this for the
5
to
4
3
.
Publicité
Chapitres
Table des Matières
