Door Conversion; Tips For Saving Energy - Proline TTR905 Mode D'emploi

socket.
3. Wipe up condensation with a cloth or sponge.
4. Wipe dry the 3-star compartment.
5. Plug in the appliance and adjust the temperature control knob as desired.

DOOR CONVERSION

If you need to hinge your door on the opposite side it is recommended that you call your local
authorised service agent to make this conversion or ask a technician.
Before you reverse the door, you should ensure the appliance is unplugged and empty. It is
recommended to use a crosshead screwdriver and a spanner (both not supplied).
1. Remove the screws (6) holding the top cover (7) to the appliance. Remove the top cover.
2. Remove the two screws (1) holding the top hinge (5) (right side) to the frame.
Remove the top hinge (5).
3. Lift the door off the bottom hinge pin and place it on a non-scratching surface.
4. Remove the two screws (8) holding the bottom hinge (2). Remove the bottom hinge (2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Before replacing the bottom hinge (2), remove the hinge pin (9) and reverse the direction of the
hinge (2). Reassemble the bottom hinge (2) on the left hand side using the two screws (8).
7. Refit the hinge pin (9) into the bottom hinge (2).
8. Lower the door onto the bottom hinge pin (9).
9. While holding the door in the closed position, reassemble the top cover (5) on the left hand side
using the two screws (1). Do not tighten the screws (1) until the top of the door is level with the
counter top.
10. Refit the top cover using the screws (6).

TIPS FOR SAVING ENERGY

For the most energy efficient use of your appliance:
x Ensure your fridge has adequate ventilation as recommended in the installation instructions.
x Allow warm food and drinks to cool down before placing in the appliance.
x Keep door openings to a minimum.
Before
GB-10
After