Tips For Saving Energy; Operating Noises; Cleaning And Maintenance; Troubleshooting - Proline PLC234WH Manuel D'utilisation

4. Reverse the middle hinge and fit it to the opposite side. Fit
the freezer door.

TIPS FOR SAVING ENERGY

For the most energy efficient use of your appliance:
 Ensure your fridge freezer has adequate ventilation as recommended in the installation instructions.
 Allow warm food and drinks to cool down before placing in the appliance.
 Thaw frozen food in the refrigerator compartment and use the low temperature of the frozen food to cool refrigerated food.
 Keep door openings to a minimum.
 Open the appliance as briefly as possible.
 Ensure that the fridge and freezer doors are always closed properly.

OPERATING NOISES

Normal noises
 Motors are running.
 Refrigerant is flowing through the tubing.

CLEANING AND MAINTENANCE

Do not use abrasive cleaning agents or solvents.
1.Disconnect the mains plug from the mains socket.
2.Take out the food and store in a cool location.
3.Clean the appliance with a soft cloth, warm water and detergent.
4.Wipe the door seal with clear water only and then wipe dry thoroughly.
5.After cleaning reconnect and set the temperature as desired.
6.Put the food back into the appliance.
The LED light in the fridge compartment cannot be replaced by the user. If the
LED light stops working, please contact the local authorised service agent.

TROUBLESHOOTING

If there is a problem with your appliance, please check the following points before contacting customer service.
Problem
Appliance does not operate.
Noises
Appliance not cool
Possible causes
No electricity at power outlet.
Cabinet not stable or level.
Temperature settings not correct.
Frequent door openings.
Large amount of food recently added.
5.Fit the fridge door and secure the upper hinge in the top frame with screws.
Secure the upper hinge cover onto the upper hinge with the screw.
Attach the upper hinge hole cover to the top of the appliance.
Possible solution
Check that the plug is correctly connected and power switched on.
See installation section.
See temperature control section.
Minimise door openings to allow temperatures to stabilise.
EN-7