Adjusting The Level For An Audio Source; Adjusting The Low-Pass Fi Lter For The Subwoofer (Buenos Aires 200 Only); Adjusting The Loudspeaker Type - Blaupunkt Buenos Aires 200 Mode D'emploi Et De Montage

u Turn the On/Off button 4 to change be-
tween the settings.
BAS L
Bass level. Settings: -7 to +7.
Turn the On/Off button 4 to perform the
u
setting.
MID L
Middle level. Settings: -7 to +7.
u Turn the On/Off button 4 to perform the
setting.
TRE L
Treble. Settings: -7 to +7.
u Turn the On/Off button 4 to perform the
setting.
BAL
Left/right volume distribution (balance). Set-
tings: L 9 (left) to R 9 (right).
Turn the On/Off button 4 to perform the
u
setting.
FAD
Front/rear volume distribution (fader). Settings:
F 9 (front) to R 9 (rear).
u Turn the On/Off button 4 to perform the
setting.
Adjusting the level for an audio
source
You can separately adjust the level for any audio
source, e.g. to achieve a uniform playback level
for all audio sources. Settings: For AUX -8 to +8,
for all other audio sources -8 to 0.
u If necessary, press the On/Off button 4
repeatedly until the desired audio source is
selected.
u Press the AUD button 9 for approx. 2 sec-
onds.
u If necessary, briefl y press the AUD button 9
to select the "V-OFF" menu item.
u Turn the On/Off button 4 to perform the
setting.
Briefl y press the MENU button ? to exit the
u
menu.
Adjusting the low-pass fi lter for the
subwoofer
(Buenos Aires 200 only)
This is possible only if the setting SWPRE SW is se-
lected in the user menu. Settings: THRU (no low-
pass fi lter), 80H (Hz), 120H (Hz), 160H (Hz).
u Press the AUD button 9 for approx. 2 sec-
onds.
The "LPF" menu item is selected.
u Turn the On/Off button 4 to perform the
setting.
u Briefl y press the MENU button ? to exit the
menu.

Adjusting the loudspeaker type

Adjust the loudspeaker type connected to the
device to optimise the sound. Settings: SP OFF
(no type selected), SP 5/4 (loudspeaker with 4 or
5 inch diameter), SP 6*9/6 (loudspeaker with
6 or 6x9 inch diameter), SP OEM (original Blau-
punkt loudspeaker).
If necessary, press the On/Off button 4
u
repeatedly until "NO SRC" is selected.
u Briefl y press the AUD button 9.
Turn the On/Off button 4 to change be-
u
tween the settings.
u Briefl y press the AUD button 9 to exit the
menu.
Sound settings
29