Led Service And Knowledge; Connection To External Equipment - DVA AL Série Notice D'utilisation

AL
instruction
manual

16) LED SERVICE AND KNOWLEDGE

Thanks to 4 led lights in different colours and located under
the volumetric "ALIA" valve display (image 9,D), we can un-
derstand what is the step the softener is in.
Each COLOUR stands for a specific function:
• Green the softener is correctly working
• Red there is an alarm
• White stands for the steps that are under way
• Blinking white indicates date, time and language setting
• Blue stands for a setting step
CAUTION: when the softener is in volumetric mode, and water
is being softened, led lights will progressively change from
green to white.
For instance: 1 white led and 3 green led lights mean that the
softener has used 25% of its operating range; while 2 white
leds and 2 green leds mean that its operating range accounts
for 50%.
Consequently, the following coding holds true:
4 BLINKING GREEN LEDs
. . .
4 BLINKING WHITE LEDs ........ LANGUAGE CHOICE
4 BLINKING WHITE LEDs ........ SETTING DATE AND TIME
4 SEQUENTIAL WHITE LEDs .... .RESIN RINSE (B3 for 5 minu-
4 SEQUENTIAL GREEN LEDs ... *R* (REGENERATION)
1) TIMER SETTINGS:
1 BLINKING BLUE LED
. . . . .
1 BLINKING BLUE LED
. . . . .
1 BLINKING BLUE LED
. . . . .
2 BLINKING BLUE LEDs
. . . . .
3 BLINKING BLUE LEDs
. . . . .
3 BLINKING BLUE LEDs
. . . . .
4 BLINKING BLUE LEDs
. . . . .
4 BLINKING BLUE LEDs
. . . . .
30
VOLUMETRIC
OPERATING/SERVICE
tes)
CHOOSE VOLUMETRIC MODE
YES-NO
REGENERATION DAY
REGENERATION DAYS
INTERVAL
REGENERATION TIME
CHOOSE MODEL 5, 8, 12
EXTRA-RINSE
CHOOSE SALT ALARM
CHOOSE BUZZER
2) INSTALLATION:
2 STEADY WHITE LEDs
. . . . .
4 STEADY WHITE LEDs
. . . . .
3 STEADY WHITE LEDs
. . . . .
4 STEADY WHITE LEDs
. . . . .
3) RESIN REGENERATION:
2 STEADY BLUE LEDs
. . . . . .
3 STEADY BLUE LEDs
. . . . . .
4 STEADY BLUE LEDs
. . . . . .
4) ALARMS:
4 BLINKING RED LEDs
. . . . .
1 STEADY RED LED
. . . . . . .
2 STEADY RED LEDs
. . . . . .
3 STEADY RED LEDs
. . . . . .

17) CONNECTION TO EXTERNAL EQUIPMENT

The ALIA valve can send signals to external equipment via the
connections showed in Fig.8, O, M.
Technical connection data are the following:
- connector "O" is based on the MOD BUS RTU protocol (RS
232 external serial connector) (Fig. 8, O).
- connector "M" is used to communicate whether salt is
present in the tank via ON/OFF signals (Fig. 8, M).
Instruction Manual AL VOLUMETRIC
ENGLISH
B3 COUNTERCURRENT RINSE
B7 1ST REFILL AND RAPID
WASH
B5 SUCKING
B7 2° REFILL AND RAPID
WASH
B3 COUNTERCURRENT RINSE
B5 SUCKING
B7 REFILL AND RAPID WASH
SALT ALARM TRIGGERED
ERROR 1
ERROR 2
REPLACE BATTERY