REPAIR
Symptom
Reason
No power supply
The device
does not
work
The fuse has blown.
The device is not parallel
to the ground. The
The device
appliance is too close to
makes a lot
the wall or the interior
of noise
accessories of the
refrigerator are placed
incorrectly.
The door is opened too
The
often or has been left
appliance
open for a long time.
does not
reach the
The refrigerator is too
desired
close to the wall.
temperature.
The refrigerator is too
full.
The temperature is
incorrectly regulated.
The device
Food has expired inside
emits bad
the refrigerator.
odors.
The interior of the
appliance needs to be
cleaned.
If your device shows other symptoms than those described above,
please call the authorized service center of the store or the dealer.
The following symptoms are not failures:
1. The sound of coolant flowing through the pipes can be heard, this is normal.
2. Moisture on the exterior surface of the unit during wet seasons is not a
problem, just wipe the surfaces with a soft, dry cloth.
3. The compressor and condenser may heat up more during periods of high
heat.
4. The door frame is a little warm, it means the condenser is working to remove
moisture from the air.
Solution
Make sure the device is
plugged in properly and the
wall outlet is working normally
Replace the fuse
Stabilize the base of the
refrigerator by adjusting the
position of the feet. Move the
device away from the wall.
Correctly place the interior
accessories of the refrigerator.
Close the door and do not open it
too frequently.
Move the unit away from the
wall to ensure proper.
Remove food from the appliance.
Turn the thermostat knob to
position "3" or higher.
Throw away expired foods
and wrap other foods.
Clean the inside of the appliance.
EN - 23