Télécharger Imprimer la page

Sibir OT 11010 FR Notice D'utilisation page 21

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE AND CLEANING
• The device should be cleaned at least once a month.
• Before cleaning, be sure to switch off and unplug the appliance.
• Remove all accessories. Wash them in lukewarm water with a mild
detergent (dish soap for example), rinse with bleach and dry thoroughly.
• Wipe the inside and outside of the refrigerator with a damp, soft cloth.
• If the device is too dirty, clean it with a soft cloth dampened with a little mild
detergent, rinse the device thoroughly and dry it with a soft cloth.
If you need to go on vacation or not use the device for a long time, please do
the following:
• Switch off the appliance and unplug it from the socket.
• Remove all food.
• Clean and dry the inside of the appliance by following the above instructions.
• Leave the appliance door open to avoid any bad odors.
Cleaning
Before cleaning, be sure to switch off and unplug the appliance.
Use a soft cloth soaked in water or non-abrasive detergent to clean the
device. Then wipe off the moisture with a soft, dry cloth. Remember to
clean the water collection tray located at the back, above the glass cover.
REVERSE DOOR OPENING DIRECTION
The refrigerator was built with the door hinges on the right. If you want to
change the opening direction of the door, be sure to follow the following
instructions:
1. Remove the cover (1). Remove the four screws (2) (3) and remove the
top cover
2. Remove the two screws (4) that hold the top hinge (5) and remove this
top hinge (5).
3. Unscrew the nut (7) and remove the pin (6). Reverse the hinge at the top
(5) and secure the pin (6) and nut (7).
4. Lift the door up and place it on a padded surface to avoid scratching it.
5. Remove the foot (8). Remove the three screws (9) that hold the bottom
hinge
(10) and be sure to remove this bottom hinge (10).
6. Loosen the screw (12) and remove the foot (13), then move it to the right
side.
7. Remove the pin (11) and reverse the direction of the bottom hinge (10).
Install the bottom hinge (10) in the left side with three screws (9).
EN - 20

Publicité

loading

Ce manuel est également adapté pour:

Ot 11010 bl