Spirotech SPIROCROSS MAGNET Manuel De L'utilisateur page 9

5.3 Lift the unit
Use approved lifting chains or straps
•
with safety hooks.
Use lifting equipment that can carry the
•
weight of the unit (WLL). Refer to
section 3.1.
1. Connect the safety hooks to the lifting lugs.
2. Make sure that the lifting chains (or straps) are
tight.
CAUTION
The hoist angle may not exceed 60°.
3. Lift the unit.
WARNING
Do not stand under the load.
CAUTION
Make sure that the unit can move freely.
4. If it is necessary to temporarily put down the unit,
put blocks under the unit and make sure the unit
rests with the main body on the blocks.
CAUTION
Do not put the bottom of the unit on the
floor. The dry pocket may get damaged
when it rests on the floor. Use the blocks.
8
5.4 Install the unit
5.4.1 Mount the unit
1. Lift the unit between the boiler/chiller (primary side)
and the system (secondary side).
2. Attach the pipework to the flanges.
NOTE
For heating installations, install the
•
pipes of the system flow line to the
upper flanges and the return line to
the lower flanges.
For cooling installations, install the
•
pipes of the system flow line to the
lower flanges and the return line to
the upper flanges.
3. Torque the fasteners to the correct torque value of
the pipework.
5.4.2 Install the drain valve
NOTE
Make sure that there is enough space to
operate the valve. If there is not enough
space, rotate the dry pocket. Refer to
section 7.3.
1. Remove the blind plug.
2. Install the drain valve. Torque the drain valve to the
correct torque value. Refer to section 3.5.
5.4.3 Finish the installation
1. Shut off the drain valve.
2. Install the safety plug.
3. Remove the protective tape from the dry pocket.
4. Attach the label with drain instructions to the dry
pocket, near the drain valve.
English User manual - 1.0