Marmitek SMART HOME Mode D'emploi page 4

Step 3
You can now control the appliance connected to the TM13 Transceiver with the
remote control
• Press the Marmitek X-10 button (home).
• Press button 1.
• Press ON (Channel +).
• The appliance connected to the TM13 is now switched on.
• Press OFF (Channel -).
• The appliance is switched off.
Step 4
Installing the LM15 Bayonet Lamp Socket.
Step 5
You can now remotely control the lamp connected to the LM15.
• Press the Marmitek X-10 button (home).
• Press button 2
• Press ON (Channel +).
• The lamp connected to the LM15 is switched on
• Press OFF (Channel -).
• The lamp is switched off
Step 6
Installing the LM12 Lamp Module.
1. Use a screwdriver to set the black dial to number 3 (this is the UnitCode. This code indicates
which button of the remote control responds to the dimmer module). The red dial should
remain set to A (this is the HouseCode. This code needs to be the same for each module).
4
• Remove the existing lamp from the bayonet socket and screw in
the LM15 Bayonet Lamp Socket.
• Screw a lamp (max. 100W open armatures, max. 60W closed
armatures) into the LM15.
• If the power is switched off, switch it back on.
• Important: Wait 30 seconds before proceeding to step 5
(after switching the electricity back on, the LM15 is set to the
programming setting for 30 seconds*. In this example, however,
we are using the standard setting).
MARMITEK