baltur LCM 100 Guide Rapide page 26

9.1.14 ELECTRICAL CONNECTION
Connect the power control unit module LCM100 to the BT300 via
plug X31 and LCM terminals 10 - 13.
As soon as you connect a LCM100 to the BT300, the inputs
i
Last- and Last+ would no longer be supported by the plug
X09. It is very important that you connect these signals as
potentialfree contacts to the LCM100 (see chapter 9.1.14.2
Terminal Assignment).
6 / 18
0006081547_201210
Resistenze da 2,2 kΩ
TPS (THREE-POINT-STEP)
POTENTIOMETER
0...10V
0/4...20MA
LED1 = POWER ON
LED2 = ERROR
LED3 = CAN DATA TRAFFIC