Pyrolytic Self-Cleaning Function - Pando PHB-961 Manuel D'utilisation

INOXPAN S.L.

8. PYROLYTIC SELF-CLEANING FUNCTION

Función disponible en los modelos pirolíticos HLB P.
Before setting the pyrolytic cleaning cycle, carefully read the safety instructions, which you will
find at the start of the Installation and Maintenance guide.
This function allows you to carry out a pyrolytic cleaning cycle during which, due to the high
temperatures reached inside the oven, accumulated grease undergoes a carbonisation process.
The general recommendation is to perform a pyrolytic cycle every 4-5 uses, using the most
suitable programme according to the level of stains present in the oven. The more stained the
oven, the longer the duration of the programme.
During the pyrolytic cycle the light inside the oven will remain off.
PROGRAMMING THE PYROLYTIC FUNCTION
Before carrying out the pyrolysis, you must remove all accessories and dishes from the oven,
including the shelves and/or telescopic guide rails. To do this, follow the instructions in the
installation and maintenance guide accompanying the oven.
Clean any spillages or excess dirt from the inside, as these could ignite during the pyrolysis and
create a fire hazard.
Before running the pyrolytic function, ensure that the oven is properly closed.
1. Turn the cooking control dial to the Pyrolysis position
2. After a few seconds, the
programme 2.
3. You can now change the pyrolysis programme to P1, P2 or P3 by pressing the
p1: Light pyrolysis. Lasts 1 hour.
p2: Regular pyrolysis. Lasts 1 hour 30 min.
p3: Intensive pyrolysis. Lasts 2 hours.
4. Once the desired programme has been selected, press
activated immediately.
symbol will light up on the clock display, reading 'P2' (Pyrolysis
.
. The automatic door lock will be
EN - 16
or keys: