Installing The Wings - Reely SKY EP « Waco » RTF 20 79 03 Notice D'emploi

Turn the clevis (1) to set the linkage rod length so that the elevator (2) is in its
neutral position.
When the rod is shortened properly, hook and attach the clevis to the medium
hole of the rudder horn (3).
c) Installing the Wings
Place the upper wing on your work place bottom up. Screw the wing brace (1)
to its receptacle (3) in the wing with two screws (2).
Caution:
The braces are labelled with the letters "LFU" and "RFU". The
place where the respective label is attached must be screwed to
the upper front of the left and right wing sides.
Screw the baldachin halves (1) to their receptacles (3) in the wing with two
screws (2).
Figure 6c
Figure 7a
Figure 7b
37