Elica EGL436S1 Mode D'emploi page 13

7. Regulate the rear spacer to cover the
clearance on the rear side once the hood
has been installed (see also paragraph
"Dimensions and clearances") and fix it
with two screws (one per side).
8. Fit the blower unit housing inside the
cabinet through the bottom opening.
Check that fixing springs goes over the
bottom panel..
9. Apply two brackets (one per side) to the
blower unit housing.........
....... lock in place (check that each
bracket , once in position, is flush to the
front side of the blower unit housing)
tighten the side fixing screws (two per
brackets) and, from the inside of the
hood, fix with one screw each then .......
13