Testing - hager EK860 Mode D'emploi

6. Testing

After installation a test of the heating system is essential. The test comprises switching on the
heater via Smart Thermostat and the subsequent switch off.
Setting the temperature
Pressing button
once: current room
temperature shows.
Set temperatur
to 25 °C.
The test has been successful when the boiler creates to the control command within
P
5 minutes. Please note that outside temperature controlled heating systems might take
a bit longer to react.
Reset the temperature to 21 °C or to the required temperature for the customer.
z
Pressing the button once more: mode shows,
using arrows to change mode to manual
(hand icon), pressing button to confirm.
Wait until the
boiler starts.
Set temperatur
to 10 °C.
z
Setpoint temperature
shows, set tempera-
ture for testing using
the arrows.
Wait until the boiler
goes out.
31