hager EK860 Mode D'emploi page 29

5.1 Opening the Installer Menu
Press and hold the
button on the Smart
Thermostat
The default setting for the first menu entry appears.
To change the settings, please use the arrow buttons.
Confirm selection by pressing the button - next menu entry is displayed
5.2 Selecting Smart Thermostat Interface
The code required for any specific heating installation can be found in the Overview of the
P
Interface Configuration page 33. Default settings are each identified with *.
Selectable *TS
range R01-R10
D01-D75
A01-A15
5.3 Selecting Smart Thermostat Heating Circuit
Selectable *HC--
range HC00-HC10
Antenna
symbol appears
and arrows show
Temperature sensor (when Extension Box is installed)
R.. relay interfaces
D.. digital interfaces
A.. analog interfaces
No heating circuit selected
Heating circuit 0 - 10
Use the up and down
buttons until the tool
symbols appears
Press and hold the
button for 3 s and the
settings will be loaded
z
29