Execute Firmware Updates For All Products In The Network In Parallel; Activate New Web Interface - Mennekes Professional+ E 7,4 / 22 Mode D'emploi

8.3.1 Execute firmware updates for all products
in the network in parallel
Requirement(s):
ü The connection to the ECU is established via a
network.
1 "6.5.3 Via the network" [} 26]
u Open the web interface of each networked ECU
in a separate tab of the web browser by enter-
ing the respective IP address.
u In each tab, navigate to the "System" menu and
execute the firmware update.

8.3.2 Activate new web interface

As of firmware version 5.12.3, the display of the
web interface has been adapted. When updating
the firmware from the old web interface (firmware
version lower than 5.12.3) to the new web interface
(firmware version 5.12.3 or higher), the new web in-
terface must be activated manually.
u Navigate to the "Operator" menu.
u Set the "Web Interface" parameter to "2.0".
u Click the "Save & Restart" button to activate the
new web interface.
44