Risk Of Burns; Risk Of Bursting; Risk From Moving Parts - Mi-T-M Corporation HG Série Mode D'emploi

READ ALL SAFETY WARNINGS BEFORE INSTALLING AND USING PRESSURE WASHER
HAZARD

RISK OF BURNS

RISK OF BURSTING

RISK FROM MOVING PARTS

8
SAFETY WARNINGS
POTENTIAL CONSEQUENCE
Serious injury may occur from
touching the heat exchanger or
vent piping. These areas can
remain hot for some time after the
pressure washer is shutdown.
Serious injury may occur from a
pressure washer malfunction or
exploding accessories if incorrect
system components, attachments
or accessories are used.
Serious injury or death may occur
if attempting to start the pressure
washer when the unit is frozen.
Serious injury may occur to the
operator from moving parts on the
pressure washer.
PREVENTION
Never allow any part of your body to
contact the heat exchanger or the vent
piping.
Never make adjustments to the factory
set pressures.
If burner fails to shut off, turn off the gas
supply and contact your serviceman.
Never exceed manufacturers maximum
allowable pressure rating of attachments.
Do not allow any hoses to make contact
with the heat exchanger to prevent the
possibility of bursting. Avoid dragging the
hoses over abrasive surfaces such as
cement.
Use only manufacturer recommended
repair parts for your pressure washer.
In freezing temperatures, the unit must
always be warm enough to ensure there
is no ice formation in the unit. Do not
start the pressure washer without first
allowing the unit to thaw.
Do not operate the unit without all
protective covers in place or make any
adjustments without shutting off the
pressure washer, relieving pressure
and disconnecting the pressure washer
from the power source. Allow pressure
washer to cool down. Never assume
the pressure washer is safe to work on
just because it is not operating. It could
restart at any time!
Operator's Manual