Winterizing - Mi-T-M Corporation HG Série Mode D'emploi

WINTERIZING:

For storage and transportation purposes in subfreezing ambient temperatures,
it will be necessary to winterize this unit. This unit must be protected to the
lowest incurred temperature for the following reasons:
1. If any part of the pumping system becomes frozen; excessive
pressure may build up in the unit which could cause the unit
to burst resulting in possible serious injury to the operator or
bystanders.
2. The pumping system in this unit may be permanently
damaged
BY WARRANTY.
If you must store your unit in an area where the temperature may fall below
32°F, you can protect your unit by following one of the procedures listed
below.
AIR BLOWOUT:
1. Remove the nozzle from the wand assembly. Squeeze the
trigger until water ceases to exit the wand assembly.
2. Connect an air fitting from an air hose to the strainer fitting in
the float tank.
3. Run compressed air into the system to remove all water from
the system.
ANTIFREEZE SOLUTION:
1. Pour a 50/50 mixture of antifreeze and water into the float
tank.
2. Place the detergent strainer into 100% antifreeze solution
3. Turn the switch to the "Pump" position. Allow antifreeze to siphon
throughout the system until antifreeze solution exits the outlet.
(To ensure the coil is winterized, antifreeze solution must exit the
outlet. Add more 50/50 mixture to the float tank if necessary.)
Operator's Manual
MAINTENANCE
if frozen. FREEZE DAMAGE IS NOT COVERED
WARNING
RISK OF UNIT BURSTING.
DO NOT STORE / OPERATE
U N I T I N A F R E E Z I N G
ENVIRONMENT!
32˚F 0˚C
27