Quick-Connect Nozzles; Nozzle Connection - Mi-T-M Corporation HG Série Mode D'emploi

QUICK-CONNECT NOZZLES:

Various nozzles may be quick connected into the end of the adjustable pressure
dual lance to change the spray pattern or use the detergent feature. When
using Quick- connects (Q.C.), be certain the connection is securely locked.
(See illustration #11). If not, the high pressure water may shoot the nozzle
from the lance, causing severe injury or serious damage. To determine
spray fan, (see illustration #12) refer to the actual number stamped on the
nozzle. The first two digits indicate the spray fan in degrees, i.e., 00=0°,
15=15°, 25=25°, 40=40°.
1. The 0° nozzle (RED): This is a blasting nozzle. It delivers a very concentrated
stream of water. Be cautious when using the straight narrow stream. It is
not recommended for use on painted or wood surfaces or items attached
with adhesive backings. Uses: Removing weeds from sidewalk cracks,
stubborn stains from concrete, masonry, aluminum and steel, caked mud
from equipment, and cleaning lawn mower undersides.
2. The 15° nozzle (YELLOW): This is a chiseling nozzle. The spray should
be directed at a 45° angle to the surface and used like a scraper to
remove paint, grease and dirt. Uses: Surface preparation (removing
mildew stains and paint chips).
3. The 25° nozzle (GREEN):
a. This is a flushing nozzle. This pattern is best suited for flushing
dirt, mud, and grime. Uses: Wet sweeping leaves from walk,
curbs and driveways, cleaning stable floors, washing swimmin
pool bottoms, degreasing engines.
b. On units with steam option, this nozzle is used for 250°F Wet
Steam operation. This nozzle is sized for operation with the
unloader and steam valve (where applicable) to provide high
pressure wet steam. Replacement of this nozzle with an improp-
erly sized nozzle may cause operational problems with the
machine.
4. The 40° nozzle (WHITE): This is a wash nozzle. This wide spray pattern
disperses the water pressure over a large area and is recommended
for moderate washing. Uses: Washing down aluminum siding, cleaning
windows, washing vehicles, spraying sidewalks, driveways, and
patios.

NOZZLE CONNECTION:

1. Ensure the trigger gun is locked in the OFF position. (See illustration
#13)
2. The quick-connect nozzle should be disconnected from the adjustable
pressure dual lance at this time. As shown in illustration #14, retract the
locking ring on the quick-connect fitting to remove the nozzle.
Operator's Manual
PREPARATION
ILLUSTRATION #14
NOZZLE CONNECTION
WARNING
RISK OF INJECTION CAUSING
SEVERE INJURY!
THE TRIGGER GUN SHOULD
ALWAYS BE LOCKED IN THE OFF
POSITION WHEN NOT IN USE!
NEVER LOOK DIRECTLY AT
THE NOZZLE UNLESS IT IS
DISCONNECTED FROM THE
TRIGGER GUN/DUAL LANCE
ASSEMBLY!
ILLUSTRATION #11
QUICK CONNECT
ILLUSTRATION #12
Q.C. NOZZLES
ILLUSTRATION #13
GUN LOCK
19