Risk Of Electrocution Or Electrical Shock - Mi-T-M Corporation HG Série Mode D'emploi

READ ALL SAFETY WARNINGS BEFORE INSTALLING AND USING PRESSURE WASHER
HAZARD
RISK OF
ELECTROCUTION
OR
ELECTRIC SHOCK
6
SAFETY WARNINGS
POTENTIAL CONSEQUENCE
Serious injury or death could result
from improper installation.
Serious injury or death could occur if
the pressure washer is not properly
grounded. Your pressure washer
is powered by electricity and may
cause electric shock or electrocution
if not used properly.
Electrical shock may occur if
pressure washer is not operated
properly.
Serious injury or death may occur
from contact with electricity.
Serious injury or death may occur if
electrical repairs are attempted by
unqualified persons.
PREVENTION
Installation of this unit including all
electrical connections must comply
with all local, state and national codes.
(Standards to be followed include NFPA
No. 70/NEC National Electrical Code.
In Canada; Refer to the CSA C22.1
Canadian Electrical Code Part 1)
This unit must be connected to a
grounded, permanent wiring system; or
an equipment-grounding conductor must
be run with the circuit conductors and
connected to the equipment-grounding
lead on the unit.
Make sure the pressure washer is
connected to a properly grounded source
which provides correct voltage and
adequate fuse protection. Disconnect
from power source when not in use or
when making repairs.
Do not attempt to light the pilot manually
as the electronic spark ignition lights the
pilot automatically.
Never operate pressure washer with
electrical enclosures open, removed or
damaged.
Do not touch machine while standing in
water or with wet hands. Never let the
electrical supply or any connections lay
in the water.
DO NOT direct spray on or into electrical
installations of any kind! This includes
electrical outlets, light bulbs, fuse boxes,
transformers, the unit itself, etc.
DO NOT allow metal components of the
pressure washer to come in contact with
live electrical components.
Any electrical wiring or repairs performed
on this pressure washer should be
done by authorized service personnel
in accordance with local and national
electrical codes.
Before opening any electrical enclosure,
always shut off the pressure washer,
relieve pressure and disconnect the
pressure washer from the power source.
Allow pressure washer to cool down.
Never assume the pressure washer is
safe to work on just because it is not
operating. It could restart at any time!
Operator's Manual