Function Introduction For Combination Buttons - Gree GWH09ACC-K6DNA1A/I Manuel D'utilisateur

Climatiseur split. inverter
Masquer les pouces Voir aussi pour GWH09ACC-K6DNA1A/I:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Introduction for buttons on remote controller
LCD displays "
scavenging functions simultaneously; LCD displays "
button for the third time to quit healthy and scavenging functions simultaneously.
Press the button for the fourth time to start healthy function; LCD display "
Press this button again to repeat the operation above.
● This function is applicable to partial of models.
16
TEMP button
By pressing this button, you can see indoor set temperature, indoor ambient temp-
erature or outdoor ambient temperature on indoor unit's display. The setting on
remote controlleris selected circularly as below:
● When selecting "
on indoor unit displays set temperature.
● When selecting "
displays indoor ambient temperature.
● When selecting "
displays outdoor ambient temperature.
Note:
● Outdoor temperature display is not available for some models. At that time, indoor
unit receives "
● It s defaulted to display set temperature when turning on the unit.There is no
display in the remote controller.
● Only for the models whose indoor unit has dual-8 display.
● When selecting displaying of indoor or outdoor ambient temperature, indoor
temperature indicator displays corresponding temperature and automatically turn
to display set temperature after three or five seconds.

Function introduction for combination buttons

Energy-saving function
Under cooling mode, press "TEMP" and "CLOCK" buttons simultaneously to
start up or turn off energy-saving function. When energy-saving function is started
up, "SE" will be shown on remote controller, and air conditioner will adjust the set
temperature automatically according to ex-factory setting to reach to the best
energy-saving effect. Press "TEMP" and "CLOCK" buttons simultaneously again to
exit energy-saving function.
Note:
Under energy-saving function, fan speed is defaulted at auto speed and it can't
be adjusted.
". Press the button for the second time to start healthy and
no display
" or no display with remote controller, temperature indicator
" with remote controller, temperature indicator on indoor unit
" with remote controller, temperature indicator on indoor unit
" signal, while it displays indoor set temperature.
" and "
15
" . Press this
" .

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières