Télécharger Imprimer la page

Tristar AC-5670 Mode D'emploi page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
Open the air inlet grille and take off air filter.
Clean the air filter with neutral detergent in lukewarm 40°C water
and allow to dry (not in direct sunlight).
Re-install the air filter into the inlet grille.
TROUBLESHOOTING
Troubles Possible Causes
The unit
Water full indicator
does not
lamp blinks and water
start
tank is full.
when
Room temperature is
pressing
higher than the setting
power
temperature.(Electric
button.
heating mode)
Room temperature is
lower that the setting
temperature.(Cooling
mode)
Suggested Remedies
Drain the water out of the
water tank.
Adjust the temperature.
The unit
The doors or windows
doesn't
are not closed.
cool
There are heat
enough.
sources inside the
room.
Hot air exhaust hose
is not connected or
blocked.
Temperature setting
is too high.
Air inlet in blocked.
Noisy.
The ground is not
level or not flat
enough.
The sound comes
from the flowing of the
refrigerant inside the
air conditioner.
E0 Code. •
Room temperature
sensor failed.
E1 Code. •
Condenser
temperature sensor
failed.
E2 Code. •
Water tank full.
Instruction manual
Make sure all the
windows and doors are
EN
closed.
Remove the heat sources
if possible.
Connect or clean the hot
air exhaust hose.
Reset the temperature.
Clean the air inlet.
Place unit on a flat, level
ground if possible.
Replace room
temperature sensor.
Replace condenser
temperature sensor.
Please empty the water
tank.
11

Publicité

loading