Initial Operation; Installing The Handle Bar; Install/Empty Grass Catchment Basket - Grizzly BRM 46-150 BSA InStart Traduction De La Notice D'utilisation Originale

GB

Initial Operation

Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Observe the Briggs & Stratton in-
struction manual supplied.
Before starting the equipment, you must
- Remove the Protective Caps
- Install the handle bar
- if necessary, mount the grass collec-
tion box, mulch kit, lateral ejection
canal
- Fill with engine oil
- Fill with petrol
- Charge and insert the battery
- Connect the connecting cable
- Adjust cutting height if required

Installing the Handle Bar

Caution! Make sure that the
Bowden cables (
machine cable (
squeezed when the grip is in-
stalled.
Mounting the lower
handlebar:
1. Remove the cap nuts and was-
hers (22) from the unit housing
(19).
2. Attach the two ends of the lower
handle (5) to the unit housing
(19).
3. Screw the lower bar (5) to
the right side of the appliance
housing (19) using the screws,
washers and cap nuts (22) pro-
vided.
108
7) and the
27) are not
Mounting the upper grip:
4. Screw the upper grip (1) to the
right and left of the lower han-
dlebar (5) using the included
quick-release levers, shims and
nuts (4).
5. Unfold upper handlebar (1)
(small picture) and push locking
lever (4) toward bar.
6. Attach the two Bowden cables
(7) and the machine cable (27)
to the lower handlebar (5) using
the cable clamps (6+24).
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Loosen the Phillips screw (32)
on the carrying handle (26).
2. Place the carrying handle (26)
on the upper side of the grass
collector (23) and screw it tight
with a Philips screw (32) from
below.
3. Clip the rubber lips into the
catcher net in the hard shell of
the grass collector (23). Place
the plastic tabs (33) over the
tubular frame.
4. Remove the transport caps from
the collector attachment.
Fixing the Grass Collection
Box onto the Equipment: