Starting Up First Time - Version With Cartridge Filter - Teuco 620 Mode D'emploi

EN

STARTING UP FIRST TIME - VERSION WITH CARTRIDGE FILTER

This procedure must be carried out when the system is first started up, and following any
operations that require the pool, the overflow tank, the filter and the recirculation pump to be
drained completely.
1. REMOVE THE CANVAS FROM THE MINIPOOL
See "Minipool Canvas" .
2. ISOLATE THE SYSTEM FROM THE POWER
SUPPLY
Set the main switch to the "OFF" position.
3. CLOSE THE VALVES
Close all section valves along the various pipelines.
4. FILLING THE MINIPOOL
Fill the pool until the water is up to the rim.
5.
Continue filling the pool, allowing the water to spill
over the edge and away to the overflow tank.
Stop filling the pool when the water reaches the
level of the first metal reinforcing hoop.
6.
Open all valves along the pipelines, except for the
system drain valve, and check that there are no
leaks from pipes or fittings.
7. POWERING UP THE SYSTEM
Set the filter pump switch to "STOP".
Power up the control panel by setting the main
switch to "ON". The filler solenoid valve will cut in
automatically to bring the water up to operating
level in the overflow tank.
36
620