First Time Start-Up Operation - Teuco 641 HA Manuel De L'utilisateur

EN
STARTING UP FIRST TIME
1 - REMOVE THE COVER FROM THE MINIPOOL
remove the cover by unhooking the straps .
2 - FILLING THE MINIPOOL
Fill the minipool until the skimmer lifts up .
The water filling the tub must not exceed 35°C .
When filling the Teuco minipool, use an external
hose, taking care not to immerse it in the water
as this could cause the water to flow back into the
mains system .
3 - SWITCH ON THE ELECTRICAL SySTEM
ATTENTION: Switch on the electrical system
AFTER having filled the minipool with water. The
main selector switch that was installed during the
installation phase of the minipool must be turned to
the "ON" position .
Check that the circuit breaker switch installed during
the pre-installation operates correctly by pressing
the test button which should intervene on the circuit .
reset the switch after testing it .
The recirculation pump automatically switches on .
Attention: Sometimes the unit does not
switch on if air has accumulated in it. To
release the air from the system, slacken the
ring of the pump until the hydromassage or
the recirculation system switches on, then
retighten the ring.
4 - WATER TREATMENT
Treat the water with products supplied by Teuco, as described in the attached manual .
Equivalent products can also be utilised .
Check that the pH value of the water is between 7.2 and 7.6 inclusive and the quantity of
chlorine is between 1 and 1.5 ppm.
The chemical control of the pH and the chlorine in the water must be effectuated frequently to
ensure the quality of the water and the correct functioning of the hydromassage unit .
18
641 HA