Teuco 620 Mode D'emploi page 33

4. Filling the minipool
Fill the pool until the water is up to
the rim.
5. Filling the sand filter
a - Remove the cap of the sand filter
by undoing the nuts and washers.
b - Place a bag over the pipe inside
the filter, for protection.
c - Pour 45 litres of water into the
container and, slowly, add 6 bags
of sand (supplied with the pool),
making certain not to damage the
inside of the filter.
CAUTION: DO NOT INHALE THE
DUST.
Having completed the above steps,
remove the protective bag and
clean the rim of the filter.
Refit the cap of the filter, greasing
the seal with vaseline.
Tighten the nuts and washers
uniformly, without forcing.
6.
Continue filling the pool, allowing
the water to spill over the edge and
away to the overflow tank.
Stop filling the pool when the
water reaches the level of the
first metal reinforcing hoop.
7.
Open all valves along the pipelines,
except for the system drain valve,
and check that there are no leaks
from pipes or fittings.
620
a
b
c
a
b
c
45 lt.
EN
x6
33