Water Treatment - Teuco 620 Mode D'emploi

EN
10. Bleeding the filter
Turn the bleed valve located on the
the filter cap.
Take care over this step, as
an accumulation of air in the
filter can cause the system
to malfunction seriously and
shorten the life of the pump.
Repeat the operation several times
if necessary .
After bleeding the filter, set the
pump switch to the "AUTO" position.

WATER TREATMENT

Treat the water using the products supplied by Teuco, as described in the accompanying manual.
Other equivalent proprietary products can also be used.
The pH value and Chlorine level must be tested chemically at frequent intervals to guarantee the quality
of the water is properly maintained and ensure correct operation of the system.
620
35