Télécharger Imprimer la page

WAGNER W 450 SE Mode D'emploi page 21

Masquer les pouces Voir aussi pour W 450 SE:

Publicité

Les langues disponibles

Les langues disponibles

W 450 SE
Spray Technique
The spray result depends heavily on the smoothness and cleanliness of the surface to be
sprayed. Therefore the surface should be carefully prepared and kept free of dust.
Test the spray gun on cardboard or a similar surface to find the correct setting.
Do not spray the vessel empty. The suction tube should always be immersed in liquid.
If air is sucked in, larger drops may result.
When spraying, hold the spray gun in a horizontal position. Use the
extension (Illus. 12 + 13/ special accessories) for spraying upwards (e.g. a ceiling) or
downwards (e.g. an unhinged door laid on the floor).
Begin spraying outside of the spray area and avoid interruptions inside the spray area.
Do not apply too much paint during one spraying operation. First apply a thin layer
and allow to dry briefly before applying a covering layer. This is especially important
with vertical surfaces to avoid paint sags.
The distance from the nozzle to the object to be sprayed depends on the delivery
rate. With a low delivery rate it is possible to go very close to the object. This reduces
the amount of spray mist.
The spray gun should be worked as evenly as possible during the spray operation.
Accelerating or slowing down during the spray operation causes an uneven spray
pattern, spattering, dripping and orange peel.
The spray movement should come from the arm, not just from the wrist. This ensures that
a uniform distance is maintained between the spray gun and the spray surface during
the spray operation (Illus. 5).
To achieve optimal spray results, spray back and forth over the surface (Illus. 6).
Cleaning and Maintenance
Important! Clean the spray gun thoroughly whenever it has been used.
Guns that have not been cleaned may malfunction! The warranty does
not apply for faults or malfunctions due to impurities. Therefore if
malfunctions occur, check the cleaned unit once more before sending it
to your sales point.
The spray gun can only operate satisfactorily if it is cleaned and preserved after each
use.
Attention! Never immerse the spray gun in liquid when cleaning.
1)
Empty out the remaining paint from the container.
2)
Put proper thinner in the container and trigger the sprayer for approx. 2 seconds.
3)
Pull the main plug out of the socket.
4)
Disassemble the spray gun as shown in Illus. 14 (spare parts).
5)
Thoroughly clean all soiled parts (Illus. 14).
6)
Reassemble the parts in reverse order.
7)
Put a few drops of oil (e.g. sewing machine oil) in the intake and runback holes (Illus.9).
Briefly switch on the spray gun.
Environmental protection
Protecting the environment: Paint or solvent remains must not be dumped in drains or
pipes. Where waste disposal is carried out by public authorities as a special service free
of charge, arrange for collection.
GB
flexible nozzle
17

Publicité

loading