Installation; Packing And Storing; Packing And Contents - Ferroli MIDAS PC10 12000 Manuel D'installation

PACKING AND STORING

All machines are packed in cardboard boxes specific for each unit. The units
must be handled manually.
The indications required to correctly handle the appliance while storing and
installing it are written on the packing.
The storage temperature must be between -25°C and 55°C.
Note: Do not throw the packing away exteriors to avoid environmental pollution.
Once the place in which the unit is to be installed has been chosen (see the
relative sections) proceed as follows to unpack the two units:
Outdoor unit:
1. Cut the two nylon straps.
2. Remove the cardboard box.
3. Remove the nylon wrapping.
Indoor unit:
1. Cut the two nylon straps.
2. Open the top part of the cardboard box.
3. Take hold of the unit and lift it until it is completely free from the packaging.
4. Remove the side protections and nylon wrapping.

PACKING AND CONTENTS

The appliances are supplied in three separate parts:
1: EXTERIOR UNIT, in cardboard wrapping with corner guards if required.
2: INTERIOR UNIT, shipped in standard packaging consisting of a cardboard box inside which the unit is protected
by two polystyrene shells sealed by nylon film.
The box contains the following items:
1 appliance.
1 electric box containing the control kit.
1 packet containing screws to fix the electric box and brackets to fix the actual unit itself, plus adapter unions to
adapt the dimensions of the cooler connections.
A packet containing documents.

INSTALLATION

Fig.1
Fig.2
9