Electrical Connection Of The Outdoor Unit - Ferroli MIDAS PC10 12000 Manuel D'installation

ELECTRICAL CONNECTION OF THE OUTDOOR UNIT

1. Unscrew the screw/s and remove the side panel (Fig. 1-1) by moving it down-
wards.
2. Make the connections referring to the wiring diagrams of the unit.
3. Close the machine up again.
ELECTRICAL CONNECTION OF THE UNIT FLOOR/CEILING INTERIOR
1. Remove the board cover.
2. Insert the wires through from the rear side or bottom, depending on the instal-
lation.
3. Make the connections with reference to the relative wiring diagrams.
4. Fit all the parts back in place.
To insert the wires into the terminal board, press on the relative cavity with a
screwdriver, fit in the stripped wire end and then release the screwdriver. make
sure that everything is firmly fixed.
NOTE: The yellow/green ground wire must be at least 20 mm longer than the
other wires.
22
INSTALLATION
Fig.1
1
Fig.2