Installation; Packing And Storing; General Notes - Ferroli DIAMANT M Série Manuel D'utilisation Et D'entretien

2. INSTALLATION

2.1 PACKING AND STORING

All machines are packed in cardboard boxes specific for each unit.
The indications required to correctly handle the appliance while storing and installing it are written on the packing.
The storage temperature must be between -25°C and 55°C.
Note: Do not throw the packing away exteriors to avoid envi-
ronmental pollution.
Once the place in which the unit is to be installed has been cho-
sen (see the relative sections) proceed as follows to unpack the
two units:
Outdoor unit:
1.Cut the two nylon straps.
2.Remove the cardboard box.
3.Remove the nylon wrapping
2.2 CONTENT
Packagings contain the units as well as accessories and technical documentation for the use and installation.Check that the following
components are present.
Description
Condensation drain fitting
Pipe adaptator
Manuals

2.3 GENERAL NOTES

In order to ensure the correct operation of the air conditioner,
always follow the designation of the units (("fig. 4 -" 1-2-3 etc.)
while making cooling and electrical connections.
The electrical connection identified with 1 (2, 3, etc.) must corre-
spond to the cooling line no.1 (2, 3, etc.).
Cooling lines 1-2-3 etc.can be easily identified by looking at the
labels on the couplings of the outdoor unit.
Image
1 or 2 a in accordace with
28
EN
fig. 3 -
Qty
1
to be use in case of indoor units
the model 18 connection
1
Installation manual
fig. 4 -
Notes
Cod. 3QE46140 - Rev. Cod. 3QE461