Changing Operating Modes And Selecting Tones - Num'axes CANIBEEP RADIO PRO Guide D'utilisation

Coding procedure for the fi rst use
1. To begin the coding procedure, CANIBEEP RADIO PRO collar must be switched On.
2. Unscrew the 4 screws of the top of CANIBEEP RADIO PRO collar with a Philips screwdriver.
3. Briefly press on the push button located inside the collar (see diagram 2): a red indicator LED will
show. Once the red LED shows, you have only 5 seconds to synchronize the remote control and
the collar.
4. Move your remote control away from the collar, pressing continuously on one of the yellow
buttons of the remote control (in case of a yellow collar) until you see the red LED going off.
5. The collar emits a beep sound: the collar has correctly recorded the code of the remote
control.
6. Check the coding of your collar by testing the operation of the CANIBEEP RADIO PRO.
NOTE: If the 5 seconds have passed before having time to code the collar, or if the code is badly
recorded in the receiver collar, you can start again by pressing the push button.
In case you have a second or third collar, renew the synchronization:
- Press on one of the orange buttons of the remote control if your collar is orange;
- Press on one of the blue buttons of the remote control if your collar is blue.
Once you have fi nished the auto-coding:
- Put the top cover back in place in the right way. Check that the LED window is located
right above the red indicator LED inside the collar (See Diagram 1). Ensure that the
rubber seal is in its groove, and check that both rubber seal and groove are clean in
order to avoid any water tightness problem.
- Firmly screw up the 4 screws in order to maintain your product's water tightness.
The auto coding system located in the collar memorizes up to 9 different codes. This memory
can become saturated if you have encoded your collar with several remote controls. In this case,
the LED fl ashes after you press the push button to code.
In order to erase this memory, press continuously on the push button until the LED is off: the
memory is empty and you can recode your collar with a remote control.

Changing operating modes and selecting tones

CANIBEEP RADIO PRO allows you to locate one to 3 dogs at the same time with different tones.
Either when they are pointing, or when they are moving or pointing.
You have the possibility of carrying out various adjustments on the collar: you thus personalize
your CANIBEEP RADIO PRO according to your requirements and the behaviour of your dog.
To change the tone emitted by your CANIBEEP RADIO PRO or to change operating modes, when
GB - 28