Num'axes CANIBEEP RADIO PRO Guide D'utilisation page 27

GB -27
Switching on the collar
Before using the collar, be sure you properly tightened the 4 screws of the top in order to
maintain the water tightness of your product.
To switch on your CANIBEEP RADIO PRO collar, move the remote control towards the collar so
that the red mark comes into contact with the magnetic switch position indicator on the back of
the collar, hold for at least one second (see diagram 5).
The collar will emit two low pitch beep sounds and the red indicator will fl ash briefl y,
indicating that CANIBEEP RADIO PRO is On.
Diagram 5
Place these two areas
together for at least 1 second
Switching off the collar
To switch off your CANIBEEP RADIO PRO collar, move the remote control towards the collar so
that the red mark comes into contact with the magnetic switch position indicator on the back of
the collar, hold for at least one second (see diagram 5).
The collar will emit one low pitch beep sound and the red indicator will fl ash briefl y indicating
that your CANIBEEP RADIO PRO collar is off.
Coding of the remote control and receiver collar (auto-coding)
The synchronization of the remote control with one or several collars is necessary only at the
fi rst use of your CANIBEEP RADIO PRO.
Coding enables the remote control and the collar(s) to work together.
IMPORTANT: before beginning the auto-coding, make sure no other person is using his
CANIBEEP RADIO PRO or other products from the NUM'AXES range close by: your receiver
collar could accidentally record the code of his remote control.