Sanitas SBM 45 Mode D'emploi page 23

cently used user memory appears (
the user memory, press the MEM button and confirm
your selection with the START/STOP button. If no button
is pressed, the most recently used user memory is auto-
matically used after 5 seconds.
• Before the measurement, the last saved test result is
briefly displayed. If there is no measurement in the memo-
ry, the instrument always displays the value .
• The cuff automatically inflates. Cuff air pressure is re-
leased slowly. If a tendency towards high blood pressure
is already detectable, the cuff is pumped up again and
cuff pressure increased further. As soon as a heart rate is
detected, the heart rate symbol
• Heart rate, systolic and diastolic blood pressure are dis-
played.
• You can cancel the measurement at any time by pressing
the START/STOP button or by pushing the touch screen
activation button to OFF.
• _ appears if it has not been possible to perform the
measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat
the measurement.
• The test result is saved automatically.
• To switch off the device, press the START/STOP button
or push the touch screen activation switch to OFF. If you
or ). To change
is displayed.
23
forget to switch off the device, it switches off automati-
cally after approx. 1 minute.
Wait at least 5 minutes before taking another measurement!
6. Evaluating results
Cardiac arrhythmia:
This instrument can identify possible cardiac arrhythmia dis-
orders during measurement and if necessary indicates the
measurement with the flashing icon
This may be an indicator for arrhythmia. Arrhythmia is a
condition where the heart rhythm is abnormal as a result of
defects in the bioelectrical system controlling the heart beat.
The symptoms (omitted or premature heart beats, slow or
excessively fast heart rate) may be caused, among other
things, by heart disease, age, physical predisposition, ex-
cessive use of stimulants, stress or lack of sleep. Arrhythmia
can only be ascertained through examination by your doctor.
Repeat the measurement if the flashing icon
played after the measurement. Please note that you should
rest for 5 minutes between measurements and not talk or
move during the measurement. If the icon
often, please contact your doctor. Any self-diagnosis and
treatment based on the test results may be dangerous. It is
vital to follow your doctor's instructions.
.
is dis-
appears