Settings - TOOLCRAFT 75 98 13 Mode D'emploi

10. Settings

• First switch off the laser distance measurement; keep the power
button „ " (D) pushed for 3 seconds.
• Keep the function button „ " (C) pushed and briefly push the
measuring button „
again.
The display indicates „UNIT", see figure on the right.
• Select the desired unit, e.g., „m" = metres, with the measuring
button „ " (B).
• Briefly push the function button „ " (C) to select the measuring
method from which housing side the distance measurement is to
start.
• Switch between the measuring methods with the measuring button
„ " (B):
A) Rear end of the laser distance meter
B) Front end of the laser distance meter
The upper left of the display shows a small figure for the respective
selected measuring method.
Depending on the measuring method, the housing length of the
laser distance meter is internally added or not.
• Terminate setting mode by briefly pushing the power button „ " (D).
Then all display segments appear and the laser distance meter is operational with the new
settings.
" (B). Release the function button „ " (C)
UNIT
37