Accessories - Stiga SHJ 550 Manuel D'utilisation

12 IDENTIFICATION OF FAULTS / TECHNICAL SPECIFICATIONS / ACCESSORIES
EN
8. IDENTIFICATION OF FAULTS
PROBLEM
1) The engine
will not start
or will not
keep running
2) The engine starts
but is lacking
in power
3) The engine runs
irregularly and lacks
in power when
revved
4) The engine gives
off an excessive
amount of smoke
9. TECHNICAL SPECIFICATIONS
MODEL .....................................................................................................
Displacement .................................................................................. cm
Power ............................................................................................... kW
Spark plug ...............................................................................................
Petrol : oil ratio .........................................................................................
Tank capacity ................................................................................. litres
Trimming length .............................................................................. mm
Operator ear noise pressure level (ISO 11201) ........................... dB(A)
Measurement uncertainty (2006/42/EC - EN 27574) .................... dB(A)
Measured acoustic output level (ISO 3744)................................... dB(A)
Measurement uncertainty (2006/42/EC - EN 27574) .................... dB(A)
Vibration level (EN 774 - EN 28662) ............................................... m/s
Measurement uncertainty (2006/42/EC - EN 12096) .................... m/s
Mass .................................................................................................. kg

10. ACCESSORIES

Only cutting tools with the following codes must
be used on this machine:
23305004/0
Given the product evolution, the above mentio-
LIKELY CAUSE
– Incorrect starting procedure
– Dirty spark plug or incorrect distance
between the electrodes
– Air filter clogged
– Carburation problems
– Air filter clogged
– Carburation problems
– Dirty spark plug or incorrect
distance between the electrodes
– Carburation problems
– Incorrect composition
of the fuel mix
– Carburation problems
SOLUTION
– Follow the instructions
(see chap. 5)
– Check the spark plug
(see chap. 7)
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Check the spark plug
(see chap. 7)
– Contact your Retailer
– Prepare the fuel mix according to
the instructions (see chap. 4)
– Contact your Retailer
3
2
2
ned tools may be replaced in time by others,
with similar interchangeable and operating
safety characteristics.
HTJ 550
24.5
0.85
NHSP LD L8RTF Y
50 : 1
0.33
610
102.1
3.0
107.1
3.0
2.97
1.5
5.5