Breville Barista Express Manuel D'instructions page 25

CLEANING THE CONICAL BURR GRINDER
This grinder cleaning cycle removes oil build-up on the burrs which can impede performance.
1 2
Unlock hopper Empty hopper
8 9
Unlock top burr Remove top burr
ADVANCED CLEANING FOR THE CONICAL BURR GRINDER
This step is only required if there is a blockage between the grinding burrs and the grinder outlet.
1 2
GRIND SIZE
POWER GRIND AMOUNT FILTER SIZE
Remove hopper Set 'GRIND SIZE' to '1'
(finest)
8 9
SINGLE
PUSH TO GRIND
Unblock the grinds exit Clean chute with brush
chute using the brush or
a pipe cleaner
WARNING
Care should be taken as the grinder burrs are
extremely sharp.
3 4
POWER GRIND AMOUNT FILTER SIZE
Replace hopper Lock hopper
10 11
Clean top burr with brush Clean lower burr with brush Clean chute with brush
3 4
LOOSEN NUT
Use 10mm socket. Rotate Set 'GRIND SIZE' to '16'
'Clockwise' to loosen the (coarsest)
nut only
10 11
DOUBLE
3
2
1
1. FELT WASHER
2. METAL WASHER
3. GRIND FAN
Insert washers & grind fan Insert lower burr (drive pin
using long-nose pliers & cavity to align). Insert
flat washer & spring washer
5
SINGLE DOUBLE
PUSH
Run grinder empty
12
SINGLE DOUBLE
PUSH TO GRIND
5
GRIND SIZE
Unlock & remove top burr
12
SPRING
WASHER
FLAT
WASHER
TIGHTEN NUT
Rotate 'Counter-Clockwise'
to tighten nut
6 7
POWER GRIND AMOUNT
Unlock hopper Remove hopper
6 7
1
SPRING
WASHER 2
FLAT
3
WASHER
1. GRIND FAN
2. METAL WASHER
3. FELT WASHER
Remove nut, spring & flat Remove grind fan & washers
washer. Carefully remove using long-nose pliers
lower burr
13 14
GRIND SIZE
Insert & lock top burr Set 'GRIND SIZE' to '5'.
Replace & lock hopper
FILTER SIZE
25