Seca 220 Mode D'emploi page 6

Congratulations!
English
In the seca 220 measuring rod, you have
acquired an accurate and at the same time
sturdy rod for measuring the height of chil-
dren and adults.
It is manufactured from stable, easy-care
aluminium profile.The measuring slide is
made of plastic and can be folded.
The seca 220 measuring rod is for measur-
ing height and thus for assessing the state
of health of patients and for detecting and
monitoring pathological nutritional or other
physiological disorders.
It is attached to the column of seca column
scales using the assembly material sup-
plied.
In combination with a scale, therefore, the
measuring rod serves as a complete meas-
uring and weighing station.
The seca 220 measuring rod is used with a
seca column scale primarily in hospitals,
general practice and measuring and nurs-
ing facilities on wards.
Safety
Before using the new measuring rod,
please take a little time to read the following
saftey instructions:
• Follow the operating instructions.
• Attach the measuring rod only to seca
column scales.
• Use the assembly material supplied.
6
• When assembling,ensure that screws
are tight and that the rod has been as-
sembled correctly (see chapter entitled
"Assembly instructions ").
• Fold down the measuring slide after
height has been measured to avoid the
risk of injury.
Assembly instructions
1. Screw the spacer to the rear (on models
700/711/712: ) of the column using
front
two screws.
2. Screw the measuring rod to the spacer.
The measuring slide and the scale point
away from the weighing platform
models 709, 710, 709f and 710f and
wards the weighing platform
models.
Measuring rod
at front
on seca
to-
on all other
Fixing hole
for seca
models 711,
712, 709f,
710f, 711f +
712f.
Fixing hole
for seca
models
700, 709,
710 and
711-
220 kg.
Fixing hole
right at the
bottom for
all other
seca
models.
Measuring rod at rear