Important Information - Safety - Simu LiveIn 2008734 Notice D'installation

1.1. General installation conditions
Before installing this product, read these instruction guidelines and safety information
carefully.
This product must be installed and commissioned by a professional in home motorisation
and automation, in accordance with SIMU instructions and applicable regulations in the
country where it is installed.
The installer must inform its customers about conditions for using and maintaining the
product.
Any use outside the scope of application specified by SIMU is prohibited. In the event of any
such use or failure to comply with the instructions given in these guidelines, SIMU will not
be held liable and the guarantee will be invalidated. Before use, check that the product is
compatible with the associated equipment and accessories.
1.2 Safety instructions
In order not to damage the LiveIn product:
- Avoid shocks and dropping the product.
- Do not spray or immerse in liquid.
- Do not use abrasive products or solvents to clean it. Its surface may be cleaned with a soft
dry cloth.
- Do not open the device.
- Do not place the product outside the building.
- Keep the LiveIn away from all metal surfaces that could adversely affect its operation
(reduced range).
- Using radio devices working on the same frequencies (e.g.: radio hi-fi headphones) can
reduce the performance of LiveIn.
This product is not designed to be used by people (including children) with impaired physical,
sensory or mental capacity, or inexperienced or uninformed people, unless they can be
supervised by or receive prior instruction about using this product from a person responsible
for their safety.
1.2.1 Special safety instructions (Motorised doors and gates)
In accordance with standard EN 12453, relating the safety in use of power-operated doors
and gates, if the LiveIn plug is used to operate an automated garage door or gate that cannot
be seen by the operator, a safety device must be fitted on this automated system. Refer
to the specific instructions for the products affected. For further information, or if in doubt,
contact SIMU or go to www.simu.com.
1.3 Scope of application
The LiveIn system is used to operate motorised equipment such a roller shutters, blinds and
garage doors equipped with safety device to protect against hazards caused by crushing,
shearing, lifting and drawing-in points. This system can also control equipment fitted with
Simu radio-Hz micro-receivers.
1.4 Recycling
Do not discard the product with household waste. Ensure it is disposed or at a collection
point or at an approved recycling centre.
I. IMPORTANT INFORMATION – SAFETY