Lumie Bodyclock ADVANCED 200 Notice D'utilisation page 7

BCAI0708 14/8/07
English
9 Setting the wake-up speed
The wake-up sequence is pre-set so the sunrise starts 30 minutes
before wake-up time.
To change the speed of the wake-up sequence...
Make sure A is OFF (button depressed).
Press P repeatedly until FADE UP 30 (or 60 or 90 or 15 or
DEMO) appears on the display.
Immediately press + or – until the desired wake-up speed appears.
Press P to move on to the next setting or wait 12 seconds for the
clock to revert to normal.
Remember to press A again so that the wake-up is ON (button
elevated).
10 Using snooze
When the beeper sounds, press – once to turn it off and leave the
light on.The beeper will sound again 9 minutes later.
If you prefer, when the beeper sounds press and hold – to turn off
the beeper and dim the light.The light will re-illuminate to full
strength over the next 9 minutes then the beeper will sound again.
11 Disabling the back-up beeper
To turn the beeper off at wake-up time when it is sounding, press A.
The beeper is pre-set to ON, to change this...
A must be OFF (button depressed).
Press P repeatedly until the program message reads BEEP ON.
Immediately press + or – until you see BEEP OFF.
Press P to move on to the next setting or wait 12 seconds for the
clock to revert to normal.
The beeper symbol
18:25 Page 7
is displayed when the beeper is on.
www.lumie.com | lumie careline 0845 658 9292 | 7