Lumie Bodyclock ADVANCED 200 Notice D'utilisation page 9

BCAI0708 14/8/07
English
14 Adjusting the brightness of the clock
display
The DISPLAY AUTO mode automatically dims the display at
sleep time (when the light is at a low level and the wake-up or
sunset sequences are set).
To set the display to remain bright, then...
A must be OFF (button depressed).
Press P until the program message DISPLAY AUTO appears.
Immediately press + or – until DISPLAY HIGH is set.
Press P to move on to the next setting or wait 12 seconds for the
clock to revert to normal.
15 Setting Sleepsound
Sleepsound is a continuous white noise 'hiss' sound that is useful to
mask outside noises when you want to sleep.
Make sure A is OFF (button depressed).
Press P repeatedly until program message SOUND OFF
appears.
Immediately press + or – until SOUND AUTO appears.This
means the Sleepsound will become quieter with the sunset, falling
silent as the light goes out.
Alternatively press + or – until SOUND PERM (sound
permanent) appears.This means whenever you turn the wake-up
on (A ON, button elevated), the Sleepsound will be heard.The #
symbol on the display shows when Sleepsound is enabled.
To turn the Sleepsound off for just one night ...while the hiss sound
is audible, press A IN and immediately OUT again.
18:25 Page 9
www.lumie.com
(white noise)
| lumie careline 0845 658 9292 | 9