GB
storing the excess cable in the storage on the base
of the appliance. .
• Connect the appliance to the power supply.
• Fill the water tank with fresh, cold water up to the
highest water level indicator . The tank light will
come on (see also 'using the appliance').
• Insert the insulated pot with the lit on, into the
appliance under the filter .
• Press the Start & Stop button .
• Allow the water to flow through the filter into the
pot.
• For optimal coffee enjoyment and for ease of use,
the appliance is equipped with various additional
features. These features can be set
individually.
2.1 Setting the end of brewing signal –
only AromaSignature
Therm DeLuxe
With the AromaSignature
is indicated by a sound signal. There are two volume
Manual_Signature_1013_Layout 1 15.10.13 08:59 Seite 14
settings (loud / quiet) or you can turn the sound off
completely.
• Press the 2-5 Cups button longer than 2 sec. The
LED starts to flash.
GB
• The table below shows the settings and the number
of times the indicator flashes.
Sound Signal
LED flash rhythm
(2-5 cups button)
• Press the 2-5 cups button
• Press the 2-5 cups button repeatedly until the
volume is reached. After each press of the button you will
desired volume is reached. After each press of the
hear the sound signal.
button you will hear the sound signal.
• Press the 2-5 cups button
• Press the 2-5 cups button
the chosen volume.
confirm the chosen volume.
• The setting chosen last remains active even if the power
• The setting chosen last remains active even if the
cable is removed from the socket.
power cable is removed from the socket.
4. Coffee preparation
3. Coffee preparation
For the best tasting coffee
• Use Melitta
®
coffee filters 1x4
For the best tasting coffee
re use
, so that it sits perfectly in the filter.
• Use Melitta
coffee filters 1x4
®
• If you are using whole beans, grind them fresh as needed.
before use , so that it sits perfectly in the filter.
• If you use ground coffee: Keep the pack tightly closed and
• If you are using whole beans, grind them fresh as
store it in the fridge.
needed.
4.1. Using the appliance
• If you use ground coffee: Keep the pack tightly closed
and store it in the fridge.
• The appliance has to be in the standby position (Eco-
Switch at position 'I')
3.1 Using the appliance
• Remove the lid from the water tank. Fill the tank with cold,
clean water. Choose the correct amount of water using the
cup or litre level indicators on the tank
• Remove the lid from the water tank. Fill the tank
water is poured into the tank, it is illuminated making it
with cold, clean water. Choose the correct amount
easier to see the level indicator marks.
of water using the cup or litre level indicators on
• Remove the filter from the holder using the lever in the fil-
the tank . As soon as water is poured into the
ter handle
. Remove the lid from the filter.
tank, it is illuminated making it easier to see the level
• Put a coffee filter into the filter. Add enough ground coffee
indicator marks.
for the desired number of cups
• Remove the filter from the holder using the lever in
• Replace the filter lid. Push the filter back into the holder
the filter handle . Remove the lid from the filter.
until you hear it click into place
• Put a coffee filter into the filter. Add enough ground
• Start brewing by pressing the Start & Stop button
coffee for the desired number of cups .
LED illuminates and brewing begins.
• Replace the filter lid. Push the filter back into the
• Aroma Signature DeLuxe: For the best aroma when
holder until you hear it click into place .
• Start brewing by pressing the Start & Stop button .
making less than 6 cups, start the appliance in '2-5 cup'
mode
. First press the 2-5 cups button
18
Start & Stop button
giving you the best aromatic coffee result even with small
amounts of coffee.
• At the end of the brewing the tank illumination turns itself
off. After the chosen warm keeping time (see point 3.2) the
Therm/
®
DeLuxe the end of brewing
®
loud
quiet
off
■
■
■■
■■
■■■
repeatedly until the desired
longer than 2 sec to confirm
longer than 2 sec to
®
. Fold the coffee filter befo-
. Fold the coffee filter
®
.
. As soon as
.
.
and then the
. This extends the brewing time
The LED illuminates and brewing begins.
• AromaSignature
aroma when making less than 6 cups, start the appliance
in '2-5 cup' mode . First press the 2-5 cups button
and then the Start & Stop button . This extends
the brewing time giving you the best aromatic coffee
result even with small amounts of coffee.
• At the end of the brewing the tank illumination turns
itself off.
• AromaSignature
brewing is indicated by a sound signal.
• After brewing you can remove the pot from the
appliance. The drip stop prevents dripping onto the
hotplate.
3.2 Using the insulated jug
• The brewed coffee flows through the central opening
in the lid directly into the jug.
• To pour the coffee press down on the closing lever
.
• To remove the lid, hold the side locks down and
simply lift up the lid. Hold the side locks down when
you replace the lid .
4. Descaling Programme
Depending on the regional water hardness the device
can become calcified over time. This leads to an
• Attention: To ensure that the descaling agent has enough
increased energy consumption caused by limescale
time to take effect, the water will only start flowing into
in the heating element which prevent the optimal
the pot after several minutes.
■■■
energy transfer to the water. Excessive calcification
• The descaling process takes about 25 minutes.
can lead to damage and affect the proper functioning of
the appliance. The red LED "DECALC" (5) lights up
• When the descaling process is complete the red and green
LEDs turn off.
while preparing coffee if there is too much limes-
cale on the heating element and indicates that the
• Aroma Signature DeLuxe: In addition, a sound signal
appliance should be descaled as soon as possible. We
notifies you when the descaling programme is finished.
recommend the use of Melitta
• The appliance turns off automatically and switches to stand
Machines.
by mode.
• To prepare the descaling process fill the water
• After the descaling process the appliance must be rinsed
tank with descaler according to the manufacturer's
through twice with clean water and without coffee to
instructions.
remove residual lime scale and descaler. See point 3.
• Press the DECALC button . The red LED
6. Cleaning and maintenance
flashes. Confirm your programme choice by pressing
• Before cleaning turn the appliance off using the ECO-
the Start & Stop button briefly. The automatic
Switch
and remove the power cable from the socket.
descaling programme starts, this is shown by the
• Never immerse the appliance or the power cable in water.
constantly illuminated green LED and the flashing red
LED.
• Clean the fixed housing parts with a soft damp cloth.
• Attention: To ensure that the descaling agent has
• Clean the parts, which come into contact with coffee (glass
enough time to take effect, the water will only start
pot, filter) after each use.
flowing into the pot after several minutes.
• Filter, filter lid, glass pot and water tank lid can be cleaned
• When the descaling process is complete the red and
in the dishwasher.
green LEDs turn off.
• The water overflow is removable
• AromaSignature
cleaned in the dishwasher.
In addition, a sound signal notifies you when the
7. Disposal instructions
descaling programme is finished.
• The appliance turns off automatically.
• Please consult your electrical retailer or local authority
• After the descaling process the appliance must be
regarding the disposal of electrical appliances
rinsed through twice with clean water and without
• Packaging is raw material and can be recycled. Please make
coffee to remove residual lime scale and descaler.
use of recycling facilities.
5. Cleaning and maintenance
. The
• Before cleaning turn the appliance off and remove
the power cable from the socket.
• Never immerse the appliance or the power cable in
Therm DeLuxe: For the best
®
Therm DeLuxe: The end of
®
Anti Calc Filter Café
®
and can also be
Therm DeLuxe:
®