Jay 126042 Mode D'emploi page 9

ENGLISH
Fig.3.0
To clean fluid pad:
Remove the cover from the foam base. Remove fluid pad from
the inner cover and wipe with warm water and soap. Rinse with
a clean, damp cloth. Then wipe dry with a clean cloth.
CAUTION!
• Never submerge the fluid pad in any liquid
• Avoid harsh cleaning or rough handling as this may lead to
a degradation of the fluid insert.
If at any time, the outer cover, inner cover, foam base, fluid
insert or any other component appears to be wearing or you
notice a degradation in the texture, contact your supplier/
Sunrise for evaluation and further instructions.
NOTE: To clean the ROHO® DRY FLOATATION®
Pad (if applicable), reference the ROHO® DRY
FLOATATION® Pad Owner's Manual Supplement for
proper cleaning instructions.
Fig.3.0 LAUNDRY CARE SYMBOLS
JAY Balance 126042
Machine wash (70° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
No chemical cleaning
MAINTENANCE& CLEANING
REASSEMBLING THE JAY BALANCE
CUSHION AFTER CLEANING
Fig.4.0
Reassemble as follows:
WARNING!
• Place the JAY Fluid or ROHO® DRY FLOATATION®
Pad on the inner cover making sure that all Velcro® strip
locations are aligned. A mis-alignment or creation of an
edge could cause an unwanted pressure point which
could lead to injury.
Insert the foam base / inner cover assembly into the outer
cover. Ensure that the zipper is at the rear of the foam base
where the pelvic loading area is located.
RE-USE
This JAY cushion is designed to be re-used. The frequency of
re-use depends largely on the way the cushion has been used
previously. It is essential that the cushion is properly cleaned
before re-use (see section "Easy Maintenance & Cleaning").
Roho® Dry Floatation® Pad
Fig.4.0
9
Fluid Insert
Inner Cover
US = Rev. C, EU = Rev.3.0