Unpacking; Useful Information; Intended Use - IKA MF 10 Mode D'emploi

Unpacking:

- Please unpack the device carefully
- Any damage should be notified immediately to the
shipping agent (post office, railway network or logistics
company).
Delivery scope:
The delivery scope drive includes:
- IKA MF 10 drive unit
- A collecting pan
- A mains cable
- A face spanner
- An allen wrench
- A fork wrench
- An operating instructions.
The IKA MF 10 analytical mill is a continuously operating
universal mill. It makes it possible to use two different grind-
ing methods which cover the greatest range of all grinding
tasks occurring in the laboratory.
Impact grinding:
Application for hard, brittle and/or dried materials or ground
materials embrittled as a result of cold (e.g. grain, coffee,
coal, etc.).
In this case, the ground material is cut by means of rotary
beaters and comminuted on the grinding surface attached
to the blow bars. The ground material is broken and eject-
ed into a suitable collecting pan by means of correspond-
ing filters. The feed dosage provides for optimal dosage
so that the mill can work at the optimal operating point.
The grinding chamber is locked so that it is dust proof,
the collecting pans are attached with standard ground
joints. Thus the loss ground material is kept to a minimum.
Range of use:
Indoor environments similar to that a laboratory of research,
teaching, trade or industry.
The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not sup-
plied or recommended by the manufacturer.
- if the device is operated improperly or contrary to the
manufacture's specifications.
- if the device or the printed circuit board are modified by
third parties.
Unpacking
The delivery scope for the impact grinding head in-
cludes:
An impact grinding surface with built-on door and three
screwed-in fastening pins, a dosing sluice, a hammer rotor,
a countersunk screw, a disk, a cover and the filter which
you ordered.
The delivery scope for the cutting-grinding head in-
cludes:
A cutting grinding head with three built-in bed knives, a
built-on door, a tabular slide valve and funnel, as well as
three screwed-in attaching pins, a plunger, a blade rotor
with three mounted rotor blades, a cheese head screw, a
disk and the filter which you ordered.

Useful information

Cutting-Grinding:
Application for soft fibrous ground material (e.g. hay, straw,
plastic waste, paper, wood, etc.).
In this case, the ground material is cut between rotary
blades and standing blades attached at the grinding sur-
face. The ground material is conveyed into the collecting
plan by means of filters here as well. The feed unit (guide
channel) makes it possible to load awkward, bulky material.
The cutting loads mean that less energy is introduced into
the ground material and thus results in less heat generation.
This keeps ground material loss to a minimum.

Intended use

Use:
The area of application for the universal mill is very exten-
sive, the list of materials which are capable of being ground
and indicated here is not complete. The scope of application
can be extended further by grinding trials with the respec-
tive grinding method and setting the appropriate grinding
parameters (rotor speed, filter hole diameter, sample prepa-
ration e.g. cooling).
17