Cooper Lighting Solutions Metalux RSRK Instructions D'installation page 8

Installation Instructions – RSRK
3. Connect Blue/Red wire male connector to Blue/Red wire female connector from LED driver output, to power second
gear tray. (Factory installed) as shown in (Figure 23) (secure wires with wire clips).
Figure 23.
4. Push wires inside and install secondary Channel cover
to tandem bracket at center with two self tapping
screws as shown in (Figure 24) and other end secured
by Retrofit end bracket (See Step 3).
N ote: Align the slot into the tab on the bracket in such a
way that straightness on the gear trays is maintained.
(Figure 25.)
Secondary
Channel Cover
Figure 24.
8
COOPER LIGHTING SOLUTIONS
Tandem Bracket
Wire Clip
Blue
Secondary Channel Cover
Primary
Channel cover
Tandem Bracket
IB519095EN Installation instructions
Connectors
Black
White
Wire Clip
Red
Connector
Secondary
Channel Cover
Figure 25.
Grey
Purple
Driver
Primary
Channel Cover
P-Nuts
Aligner tab
Aligner Slot
Tandem Bracket
Primary
Channel cover