Cooper Lighting Solutions Metalux Value High Bay Instructions D'installation

IL507001EN
Installation Instructions – Value High Bay
Instructions d'installation – Value High Bay
Instrucciones de instalación – Value High Bay
WARNING
Risk of re, electrical shock, cuts and or other casualty
hazards. This product must be installed in accordance
with the applicable installation code by a quali ed
electrician or a person familiar with the construction
and operation of the product and the hazards
involved.
responsibility for claims brought about by improper or
careless installation or handling of this product.
WARNING
Risk of Fire and Electric Shock. If not quali ed, consult
an electrician.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
ATTENTION Receiving Department: Note actual fixture description of any shortage or noticeable damage on delivery
receipt. File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must be filed within 15
days of delivery. All damaged material, complete with original packing must be retained.
INSTALLATION
N ote: Fixture to be installed no less than 18"[457mm]
from the ceiling surface.
Fixture CANNOT be used as a surface mounted
fixture.
Cable/Y-Toggle Suspension Installation
1. Locate and install cable to the support structure with
the cables spaced approximately 18"[457mm] apart.
2. Slip the toggle ends through the holes on the upper
flanges of the end plate. (Figure 1.)
3. Level the fixture by adjusting the cable length to
the support structure while maintaining a minimum
distance to the ceiling of 18"[457mm].
4. Open the housing cover and locate and remove the
desired knockout for supply voltage entry.
5. Connect input wiring to driver disconnect provided.
6. Close cover.
Edges May Cut. Handle with care.
Risk of burn. Disconnect power and allow fixture to cool
assumes no before changing bulb or handling fixture.
NOTICE: Green ground screw provided in proper location.
Do not relocate.
NOTICE: Minimum 90° supply conductors.
N ote:
Figure 1.
Single Point Mounting Installation
Refer to Single Point Mounting Instructions, IB519029EN
included with the SPM kit sold separately.
Wire Guard Installation
Refer to Wire Guard Installation Instructions, IB519031EN
included with the Wire Guard kit sold separately.
Brand Logo
reversed out of
black
INS # INS #
CAUTION
CAUTION
Specifications and dimensions subject to change
without notice.