Cooper Lighting Solutions Metalux RSRK Instructions D'installation page 5

3. EM ONLY - Remove KO in the centre of accessory
bracket and Install EM Test Switch into hole, ensuring
connector is accessible. (Figure 12.)
Test Switch
KO
Figure 12.
4. Wiring - Hang RSRK Gear tray to allow for wiring
(Figure 13), make the connection between EM unit and
LED Driver. Wire incoming power connections (ensure
power is off).
LED Driver
EM Connectors
Figure 13.
5.
Accessory
Bracket (EM)
Figure 14.
EM Unit
Access Plate
Bracket
Figure 15.
COOPER LIGHTING SOLUTIONS
Installation Instructions – RSRK
Route the wires - route cables through holes in gear
tray, install grommets to prevent wire damage, use
wire management clips to locate wires away from
screws and leave enough cable to make connections to
switch/sensor.
Wire Clip
EM Connector
MS Connector
Test Switch
IB519095EN
Grommet
Slit
MS Connector
Mini Integrated
Sensor
5
Installation instructions