Cooper Lighting Solutions Metalux RSRK Instructions D'installation page 7

Tandem 6Ft and 8Ft versions of product (steps 1-4)
1. In 6 ft and 8 ft assemble tandem bracket to Primary channel cover (Factory installed) with two self-tapping screws as
shown in (Figure 20). Install tether cable to Housing and Channel cover see step 5 in page 3.
Self-Tapping Screws
Aligner tab
Figure 20.
2. Push all wires and P-Nuts back inside fixture housing by leaving P-Nuts are available to connect secondary channel cover
wires to primary channel cover at center, then screw primary channel cover to retrofit end bracket installed (see step 3 in
page 2) by using two self-tapping screws. (Figures 21 & 22.)
Figure 21.
Retrofit Channel
Cover
Tandem Bracket
Self-Tapping Screws
Retrofit Channel
Cover
Housing
COOPER LIGHTING SOLUTIONS
Installation Instructions – RSRK
Retrofit Channel
Cover
Figure 22.
Self-Tapping Screws
Housing
IB519095EN Installation instructions
7