Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – RSRK
6.
EM and MS - Install Retrofit end brackets on each end
of fixture and then assemble retrofit channel cover
to retrofit end brackets (see step 2 in page 7). Mate
connectors on Sensor and/or EM test switch. Mount
access plate bracket with Sensor and/or EM Test switch
to the retrofit channel cover using self tapping screws.
Dimples are provided at 2 places to guide for screw
location (Figure 16, 18). Do not damage any wires.
Retrofit Channel
Cover
Dimples
Self Tapping Screws
Figure 16.
Access Plate
Bracket
Test Switch
Figure 17.
Retrofit
Channel
Dimples
Self Tapping Screws
Figure 18.
6
COOPER LIGHTING SOLUTIONS
Mini Integrated
Sensor
Connector
Sensor
Sensor
IB519095EN
Installation instructions
7 .
Install Lens if applicable (Figure 19), then power the
unit and test functionality of all components, do not
remove RED Stop sign on EM Test Switch until power
is applied to the charging circuit of EM Unit to prevent
battery discharge.
Figure 19.
N
ote:
Lenses are optional: There are two lens versions.
Round is shown. The Trilobe lens installs in the same
way. Ensure the lens is fully installed in each of the
gear tray tabs.
Retrofit Channel
Cover
Lens
Lens Hook
EM Only
Publicité
