1. Turn the TREBLE -/+ controller to enhance or moderate
the treble.
BALANCE (main unit only)
1. Turn the BALANCE L/R controller on the main unit to
adjust the balance of the sounds output from the left and
right speakers.
Switching the unit to power
amplifier mode
1
3"
Perform the following operations to switch the unit to power
amplifier mode to use this unit as a power amplifier when
you have connected a pre-amplifier to the MAIN IN jack on
this unit (p12).
0 Power amplifier modes settings are not available if
headphones are connected.
1. Press and hold MAIN IN until the "DIRECT" and "MAIN
IN" indicators light on the main unit. Press and hold MAIN
IN to cancel the power amplifier mode.
Note that the power amplifier mode is not canceled even
if this unit goes to standby mode.
0 When you cancel the power amplifier mode, BASS,
TREBLE, BALANCE, DIRECT, and PHASE MATCHING
BASS revert to the settings prior to changing to the power
amplifier mode.
0 There is no audio output from the PHONES jack and
LINE OUT jacks while the power amplifier mode is
engaged. The following functions are also unavailable
while the power amplifier mode is on.
"Speaker impedance settings" (p14) / "RI function
settings" (p15) / "Switching input and adjusting the
volume" (p16) / "Subwoofer output settings" (p17) /
"Adjusting the sound quality and balance" (p18) /
"Setting auto standby" (p20)
0 When switched to power amplifier mode, if the volume of
the connected pre-amplifier is low, auto standby (p20)
may function and the power may automatically switch to
standby. If this happens, you may be able to fix it by
increasing the volume on the pre-amplifier.
0 Also read the instruction manual of the pre-amplifier you
connected to this unit.
Basic Operations
19
En